Emmaaz
10/08/2011, 18:23
KHX1600C9AD3B1/2G 9-9-9-27 v1.65
Precio $350.- pesos argentinos
Ubicación geográfica: -Vivo Argentina, Buenos Aires,Partido 3 de Febrero, Caseros.
-Trabajo Argentina Buenos Aires, Ciudad autónoma de Buenos Aires (Capital Federal), Micro Centro.
Forma de pago: Efectivo o Deposito Bancario
Forma de envío: A Convenir costo a cargo del comprador.
Tiene la pieza alguna modificación: NO
Estado de conservación: Están con sus respectivos Blisters, todo en perfecto estado, solo 6 meses de uso!
Estado de la garantía: De por vida con la factura de compra, la cual poseo.
Cuento con dos modulos, osea en 2x2gb. como el kit de kingston mismas especificaciones. se van juntos!
http://www.oficor.com/images/26/IT_508kingston_khx1600c9ad3b12g_hyperx_blue_2gb_dd r31.jpg
ESPECIFICACIONES (http://www.valueram.com/datasheets/KHX1600C9AD3B1_2G.pdf)
KHX1600C9AD3B1/2G
2GB 256M x 64-Bit DDR3-1600MHz
CL9 240-Pin DIMM
Kingston.com Document No. 4805800-001.B00 07/18/11 Page 1
DESCRIPTION
This document describes Kingston’s 256M x 64-bit 2GB
(2048MB) DDR3-1600MHz CL9 SDRAM (Synchronous
DRAM) memory module, based on sixteen 128M x 8-bit
DDR3 FBGA components. This module has been tested to
run at DDR3-1600MHz at a low latency timing of 9-9-9-27
at 1.65V. The SPD is programmed to JEDEC standard latency
DDR3-1333MHz timing of 9-9-9 at 1.5V. This 240 pin
DIMM uses gold contact fingers and requires +1.5V. The
JEDEC standard electrical and mechanical specifications
are as follows:
SPECIFICATIONS
CL(IDD) 9 cycles
Row Cycle Time (tRCmin) 49.5ns (min.)
Refresh to Active/Refresh 110ns
Command Time (tRFCmin)
Row Active Time (tRASmin) 36ns (min.)
Power 1.800 W (operating)
UL Rating 94 V - 0
Operating Temperature 0° C to 85° C
Storage Temperature -55° C to +100° C
FEATURES
• JEDEC standard 1.5V ± 0.075V Power Supply
• VDDQ = 1.5V ± 0.075V
• 667MHz fCK for 1333Mb/sec/pin
• 8 independent internal bank
• Programmable CAS Latency: 5,6,7,8,9,10
• Posted CAS
• Programmable Additive Latency: 0, CL - 2, or CL - 1 clock
• Programmable CAS Write Latency(CWL) = 7(DDR3-1333)
• 8-bit pre-fetch
• Burst Length: 8 (Interleave without any limit, sequential with
starting address “000” only), 4 with tCCD = 4 which does
not allow seamless read or write [either on the fly using A12
or MRS]
• Bi-directional Differential Data Strobe
• Internal(self) calibration : Internal self calibration through ZQ
pin (RZQ : 240 ohm ± 1%)
• On Die Termination using ODT pin
• Average Refresh Period 7.8us at lower than TCASE 85°C,
3.9us at 85°C < TCASE ≤ 95°C
• Asynchronous Reset
• PCB : Height 1.180” (30.00mm), double sided component
Continued >>
Si entraste deja up de onda!
$350 pesos
Precio $350.- pesos argentinos
Ubicación geográfica: -Vivo Argentina, Buenos Aires,Partido 3 de Febrero, Caseros.
-Trabajo Argentina Buenos Aires, Ciudad autónoma de Buenos Aires (Capital Federal), Micro Centro.
Forma de pago: Efectivo o Deposito Bancario
Forma de envío: A Convenir costo a cargo del comprador.
Tiene la pieza alguna modificación: NO
Estado de conservación: Están con sus respectivos Blisters, todo en perfecto estado, solo 6 meses de uso!
Estado de la garantía: De por vida con la factura de compra, la cual poseo.
Cuento con dos modulos, osea en 2x2gb. como el kit de kingston mismas especificaciones. se van juntos!
http://www.oficor.com/images/26/IT_508kingston_khx1600c9ad3b12g_hyperx_blue_2gb_dd r31.jpg
ESPECIFICACIONES (http://www.valueram.com/datasheets/KHX1600C9AD3B1_2G.pdf)
KHX1600C9AD3B1/2G
2GB 256M x 64-Bit DDR3-1600MHz
CL9 240-Pin DIMM
Kingston.com Document No. 4805800-001.B00 07/18/11 Page 1
DESCRIPTION
This document describes Kingston’s 256M x 64-bit 2GB
(2048MB) DDR3-1600MHz CL9 SDRAM (Synchronous
DRAM) memory module, based on sixteen 128M x 8-bit
DDR3 FBGA components. This module has been tested to
run at DDR3-1600MHz at a low latency timing of 9-9-9-27
at 1.65V. The SPD is programmed to JEDEC standard latency
DDR3-1333MHz timing of 9-9-9 at 1.5V. This 240 pin
DIMM uses gold contact fingers and requires +1.5V. The
JEDEC standard electrical and mechanical specifications
are as follows:
SPECIFICATIONS
CL(IDD) 9 cycles
Row Cycle Time (tRCmin) 49.5ns (min.)
Refresh to Active/Refresh 110ns
Command Time (tRFCmin)
Row Active Time (tRASmin) 36ns (min.)
Power 1.800 W (operating)
UL Rating 94 V - 0
Operating Temperature 0° C to 85° C
Storage Temperature -55° C to +100° C
FEATURES
• JEDEC standard 1.5V ± 0.075V Power Supply
• VDDQ = 1.5V ± 0.075V
• 667MHz fCK for 1333Mb/sec/pin
• 8 independent internal bank
• Programmable CAS Latency: 5,6,7,8,9,10
• Posted CAS
• Programmable Additive Latency: 0, CL - 2, or CL - 1 clock
• Programmable CAS Write Latency(CWL) = 7(DDR3-1333)
• 8-bit pre-fetch
• Burst Length: 8 (Interleave without any limit, sequential with
starting address “000” only), 4 with tCCD = 4 which does
not allow seamless read or write [either on the fly using A12
or MRS]
• Bi-directional Differential Data Strobe
• Internal(self) calibration : Internal self calibration through ZQ
pin (RZQ : 240 ohm ± 1%)
• On Die Termination using ODT pin
• Average Refresh Period 7.8us at lower than TCASE 85°C,
3.9us at 85°C < TCASE ≤ 95°C
• Asynchronous Reset
• PCB : Height 1.180” (30.00mm), double sided component
Continued >>
Si entraste deja up de onda!
$350 pesos